Thanks guys, I have located the problem. I pulled the MB as suggested and Found that one of the pins' Spreader claws/feet (Or whatever there called) had bent. (The little clear plastic claws that split when you apply pressure) One Had ended up on the top side of the MB and the other went through the hole like it was supposed to. I was unable to bend it back far enough to fit it through the hole again, so I just ordered another, slightly different HS/F.(
This one)Its probably not the best one, but, I have used it before on my first build, and its doing alright 6 months later. Anyway once I get it installed, I'll report back with my temps. Speaking of which what is the range in which this peticular processor should run?