|
ok i changed the pio to dma mode, however that does not fix the problem of there resources or the code 12.
i changed it to dma if availlable but it says it is still using pio mode.
at boot the computer reads the both ide channels because i can see all the devices connected but when i get into windows the drives no longer work.
how do i free up resources? i went through the troubleshooting thing but i couldnt uncheck "use automatic settings"
the primary ide is using i/o range 01F0-01F7 and 03F6 and IRQ 14
i think the conflict is that the primary ultra ata/atapi channel is using the same i/o range and IRQ channel.
the same goes for the secondary ide except is it using i/o range 0170-0177 and 0376 and IRQ 15. this is conflicting with the secondary ultra ata/atapi.
any ideas. thanks
|