PCMech Forums - View Single Post - Having problems with a new build? Try this.

highrisemech · 03-04-2002, 07:05 PM

Check your manual there is a jumper for it. You should always do your homework before attempting a build. You can read about cmos at the home page of this site. You can also reset your cmos by removing the battery for three mins with the computer off then reinstallit then power up. In my opinion though you should locate this jumper and make sure it is not in the reset position.

03-04-2002, 07:05 PM	#39
highrisemech Member (12 bit) Join Date: Jul 2001 Location: Philadelphia, Pennsylvania Posts: 2,067	Check your manual there is a jumper for it. You should always do your homework before attempting a build. You can read about cmos at the home page of this site. You can also reset your cmos by removing the battery for three mins with the computer off then reinstallit then power up. In my opinion though you should locate this jumper and make sure it is not in the reset position.