|
Pick your fan size, purchase it, and do your measurements as to where you want it to be. Cut a hole (with a dremel or similar) so that the outer edges of the fan will make contact with the case. From there you can punch holes where the screws will go. Make sure the holes are smaller than the screw size. You might want to drill the hole if the case is plastic or a little flimsy.
If you just want one fan, stick it in the back, where the mount has already been made. It should be all you need for some basic cooling.
__________________
TFH, paraphrased:
the bultin brner wouldnt evn boot it a usb burner woud but ten it gaeve an eror after i typed teh prduct key. i dont no waht it was it was a missng file, i fergt waht ti was but ti loked imporant can any1 help PLZ?!
Check out PCP! (that's PCProfiles in case you thought I was on angel dust) http://www.pcprofiles.com/p/hitchface
|