Quote:
Originally Posted by inflames988
yeah i think the stuff from the auto store would probably work better - its hard to slice a long length of round wire down the middle and sometimes gets a bit messy, so i might check out the trim stuff they sell for car doors and fenders, or vacuum tubing like you said cause that might work better. no matter how much dremel time i put in on the thing i can never get it to look 100% smooth so covering it usually does the trick and looks pretty good.
|
the best thing for cutting out fan blowholes is a hole saw; just get the right size and use a reg power drill. Those things last forever and they give you perfect holes every time. Just mark out where the center of the hole is going to be, drill a pilot hole there, then use the hole saw. Works every time - just be sure to have the piece your working on secured to your workspace. heres a link to show you guys what they look like:
http://www.jarmetals.com/images/2_3-8holeSaw.jpg
you can find these at your local hardware store and theyre a little over 10 dollars or so