|
After the successful cloning,when the system shutdown, I removed the old drive (from the laptop), removed (from the upgrade kit enclosure) the cloned drive, installed the cloned drive into the laptop and installed the old drive into the enclosure; then tried to reboot. Got the message "loading PBR for descriptor", then could go no further. Turned off the laptop. Removed the cloned drive from the laptop, removed the old drive from the enclosure, put the old drive back in the laptop, and the cloned drive into the enclosure. Reboot successful, although PM (from above post) had an error message that indicated PM could not read the drive and it was created incorrectly.
|