PCMech Forums - View Single Post

rbrandes · 05-08-2013, 01:50 PM

glc,
I will be running SW2012 Preimum which I can get for $200. Just like AutoCad, SW has gone beyond the 80/20 ratio of what it has vs what you use.
Right now I have SW 2010 and there is too much there for my engineering needs.
I trained AutoCad Designer, ProE, ProJr and was in on SolidWorks when it was still beta. Must have sold a couple hundred seats when a demo jock in Georgia.
Regards, Ray

PS: I have my build in my in basket at newegg and with keyboard, mouse and monitor it comes in at $1,482.88 Thank you for leading the way.
BTW, will I be needing any cables, heat sink grease or anything else that will halt the assembly?

05-08-2013, 01:50 PM	#11
rbrandes Member (4 bit) Join Date: May 2013 Posts: 8	glc, I will be running SW2012 Preimum which I can get for $200. Just like AutoCad, SW has gone beyond the 80/20 ratio of what it has vs what you use. Right now I have SW 2010 and there is too much there for my engineering needs. I trained AutoCad Designer, ProE, ProJr and was in on SolidWorks when it was still beta. Must have sold a couple hundred seats when a demo jock in Georgia. Regards, Ray PS: I have my build in my in basket at newegg and with keyboard, mouse and monitor it comes in at $1,482.88 Thank you for leading the way. BTW, will I be needing any cables, heat sink grease or anything else that will halt the assembly? Last edited by rbrandes; 05-08-2013 at 01:53 PM.