PCMech Forums - View Single Post

Confused · 05-14-2002, 01:46 PM

If cable is connected correctly, connector after twist to drive and other end to mobo. Check that no pins are bent. Check BIOS settings under CMOS setting that Drive "A" is set to 1.44 and nothing is entered for Drive "B". Also under advanced settings check that Swap Floppy Drive is disabled. As a last resort try a different cable.
Chas

05-14-2002, 01:46 PM	#4
Confused Member (13 bit) Join Date: Nov 1999 Location: Mt Washington, KY Posts: 4,927	If cable is connected correctly, connector after twist to drive and other end to mobo. Check that no pins are bent. Check BIOS settings under CMOS setting that Drive "A" is set to 1.44 and nothing is entered for Drive "B". Also under advanced settings check that Swap Floppy Drive is disabled. As a last resort try a different cable. Chas __________________ I may not be much, but I'm all I think about.