Anyone know if this is accurate or no? I just built my new system (ASUS CUSL2; P3 800e). I bought from STEP withe their fan & bonded heatsink and am getting some weird results. I ran 3D MARK and at the end I had a temp spike indicated of 157. I shut down and checked heatsink with my pinky and it was stone cold. If this ASUS probe software is inaccurate then any recomendations (motherboard moniter, etc) I have mb moniter 4 and it don't seem to work with heat sensors. I am using rain and it really works with this setup. Anyone know the fan output on these single fan STEP units? it is no big deal to put a more powerful one on if needed. I even get temp spikes in my word processor? Weird. I am using an INWIN S500 case with both front & rear fans so I am getting good airflow. Anyone have any ideas???
|