PCMech Forums - View Single Post - idea for a casemod dd thoughts, pos or negative

ts_letter · 03-17-2003, 04:56 PM

ok I did a little research now http:\\www.cheaperthandirt.com sells a 50 cal ammo can now if this is what your looking at to build your case it is only 11" l x 5.5" w x 10" d. So it will be a tight fit close to desktop size. If you really decide to do this I belive the best thing to do is cut a small hole as an exit for the cables and not to remove the whole side. if you put a small hole at the back of the lid then you can pop open the lid and through the cables inside but unless I have the kind of ammo can you want wrong then it will be a tight fit and your drives will have to be on there sides.

03-17-2003, 04:56 PM	#9
ts_letter Member (9 bit) Join Date: Mar 2003 Posts: 372	ok I did a little research now http:\\www.cheaperthandirt.com sells a 50 cal ammo can now if this is what your looking at to build your case it is only 11" l x 5.5" w x 10" d. So it will be a tight fit close to desktop size. If you really decide to do this I belive the best thing to do is cut a small hole as an exit for the cables and not to remove the whole side. if you put a small hole at the back of the lid then you can pop open the lid and through the cables inside but unless I have the kind of ammo can you want wrong then it will be a tight fit and your drives will have to be on there sides.