PCMech Forums - View Single Post

donsopp · 03-21-2003, 08:42 AM

Ok have looked at BIOS. No setting to go to CAS3 only 2.5 Other settings do not clear problem. Ram was purchased specifically described as recommended for this board. When I set the parameters at 133 and multiplier 12.5/13 (it is a combined setting) then either the system locks and I need to clear the CMOS or Windows XP home repeatedly boots Don't know if this makes it any clearer but still can only run with it showing as a 1500+. Think I'll take the fan off again and make sure of the CPU spec.

03-21-2003, 08:42 AM	#6
donsopp Member (6 bit) Join Date: May 1999 Location: UK Posts: 35	Ok have looked at BIOS. No setting to go to CAS3 only 2.5 Other settings do not clear problem. Ram was purchased specifically described as recommended for this board. When I set the parameters at 133 and multiplier 12.5/13 (it is a combined setting) then either the system locks and I need to clear the CMOS or Windows XP home repeatedly boots Don't know if this makes it any clearer but still can only run with it showing as a 1500+. Think I'll take the fan off again and make sure of the CPU spec.