PCMech Forums - View Single Post - ICS using dial up in 2k can't see host or call on dialup

videobruce · 06-23-2003, 09:43 AM

I have read the M$ KB articles on ICS and dial up, but can't get the client to call the dial up on the Host (Gateway) computer through a wireless NIC/router setup.

I looked at the settings and both are on the same domain name, both have the IP address set for automatic. ICS is enabled on the host.

The setup is:

Win 2k
Host (Gateway, tower box) wired NIC
Client (Laptop box) wireless NIC

Compaq CP-2W router.
Dial up ISP.

Host can see client, but client CAN'T see host or call up the dialup.
Dialup works from host ok.

What am I missing? Hope this makes sense.

06-23-2003, 09:43 AM	#1
videobruce Member (10 bit) Join Date: Mar 2002 Location: Buffalo NY Posts: 512	ICS using dial up in 2k can't see host or call on dialup I have read the M$ KB articles on ICS and dial up, but can't get the client to call the dial up on the Host (Gateway) computer through a wireless NIC/router setup. I looked at the settings and both are on the same domain name, both have the IP address set for automatic. ICS is enabled on the host. The setup is: Win 2k Host (Gateway, tower box) wired NIC Client (Laptop box) wireless NIC Compaq CP-2W router. Dial up ISP. Host can see client, but client CAN'T see host or call up the dialup. Dialup works from host ok. What am I missing? Hope this makes sense. Last edited by videobruce; 06-23-2003 at 09:47 AM.