PCMech Forums - View Single Post

LawyerRon · 08-30-2003, 08:06 PM

Check out this link at fixyourownprinter.com:

http://www.fixyourownprinter.com/cgi...rother+HL-10V+

"Bill" from the site recommends this:

"Take out the drum/cartridge. Look at where the scanner shoots a beam on to the drum. There should be a metal grid if you will that has toner build up on it.
Take some canned air, and blow this out. Several of our customers have had this problem and this cure has worked.
I do not know why this happens( could be an indication that the drum is going bad) but have had zero call backs since the fix."

And there's another post regarding the corona wire and voltage so check it out.

08-30-2003, 08:06 PM	#3
LawyerRon The Gavel Join Date: Dec 1999 Location: Upland, CA Posts: 6,311	Check out this link at fixyourownprinter.com: http://www.fixyourownprinter.com/cgi...rother+HL-10V+ "Bill" from the site recommends this: "Take out the drum/cartridge. Look at where the scanner shoots a beam on to the drum. There should be a metal grid if you will that has toner build up on it. Take some canned air, and blow this out. Several of our customers have had this problem and this cure has worked. I do not know why this happens( could be an indication that the drum is going bad) but have had zero call backs since the fix." And there's another post regarding the corona wire and voltage so check it out. __________________ "To speak ill of others is a dishonest way of praising ourselves" Last edited by LawyerRon; 08-30-2003 at 08:10 PM.