PCMech Forums - View Single Post

padawan · 05-28-2000, 08:57 PM

I'll post the whole ordeal over at Maximum3D, since this is to be the new testbed for the site. The old o/c Celeron was getting a little long in the tooth, so I started getting the Athlon system ready, and ordered a Celeron II 566 (the new flip chip that is hitting 850Mhz+)and Abit Slocket!!! as our "low-end" system for testing purposes. I'm planning on photographing the whole thing, and making an Athlon o/c tutorial out of it. I have researched the Athlon memory, but I really wanted hear what people are using, since sometimes "Athlon Certified" doesn't mean crap. I think I'm going to get either the 128MB High Performance w/ Mosel REV1.5 PC133 222 or Azzo's Infineon PC133. Should be some good information over there next week, as all the parts are supposed to be in this week. It's ok if I pimp Max3D here, right? Hehe.

-Scott

[This message has been edited by padawan (edited 05-29-2000).]

05-28-2000, 08:57 PM	#6
padawan Member (10 bit) Join Date: Jun 1999 Location: California Posts: 894	I'll post the whole ordeal over at Maximum3D, since this is to be the new testbed for the site. The old o/c Celeron was getting a little long in the tooth, so I started getting the Athlon system ready, and ordered a Celeron II 566 (the new flip chip that is hitting 850Mhz+)and Abit Slocket!!! as our "low-end" system for testing purposes. I'm planning on photographing the whole thing, and making an Athlon o/c tutorial out of it. I have researched the Athlon memory, but I really wanted hear what people are using, since sometimes "Athlon Certified" doesn't mean crap. I think I'm going to get either the 128MB High Performance w/ Mosel REV1.5 PC133 222 or Azzo's Infineon PC133. Should be some good information over there next week, as all the parts are supposed to be in this week. It's ok if I pimp Max3D here, right? Hehe. -Scott [This message has been edited by padawan (edited 05-29-2000).]