PCMech Forums - View Single Post - can't find any info about this mother and...

hiramgrant · 05-13-2001, 11:25 PM

I am going off my best guess. it is an Anaheim-2/2A/3 Micro ATX (ATX V1.2 form factor) motherboard, TriGem, Korea Intel Socket-370 (370pin PPGA Socket) for Intel PentiumIII and Celeron CPUs, Integrated graphics controller Intel FW82810 core and ITE8702F Super I/O controller Crystal CS4280/CS4281 built-in Sound Blaster Pro, MPC-3, MPU-401 compatible Audio Enhanced Stereo full duplex operation. On the emachine tech support web site it says this is the same motherboard they use with their 800MHz pentium 3 emonster. I have a 600 celeron and am thinking of putting in a p3. The current Front Side Bus is 100 and I am wondering if one, can I put in a chip with a 133 FSB, and two, will it work to use an 850 p3 and go past what emachine does by 50MHZ. Thank you for your time.

05-13-2001, 11:25 PM	#1
hiramgrant Member (3 bit) Join Date: May 2001 Posts: 4	can't find any info about this mother and... I am going off my best guess. it is an Anaheim-2/2A/3 Micro ATX (ATX V1.2 form factor) motherboard, TriGem, Korea Intel Socket-370 (370pin PPGA Socket) for Intel PentiumIII and Celeron CPUs, Integrated graphics controller Intel FW82810 core and ITE8702F Super I/O controller Crystal CS4280/CS4281 built-in Sound Blaster Pro, MPC-3, MPU-401 compatible Audio Enhanced Stereo full duplex operation. On the emachine tech support web site it says this is the same motherboard they use with their 800MHz pentium 3 emonster. I have a 600 celeron and am thinking of putting in a p3. The current Front Side Bus is 100 and I am wondering if one, can I put in a chip with a 133 FSB, and two, will it work to use an 850 p3 and go past what emachine does by 50MHZ. Thank you for your time.