PCMech Forums - View Single Post - Need help setting Bios and copying data to new drive

marvontherim · 10-30-2004, 09:51 AM

glc,

There is a jumper, it is set on the third set of pins from the power cord.
Sorry the older I get the worst my eye's are.
This drive took the place of a disk drive in the secondary slave position.
The cable is a 40 pin not the 80 if that makes a difference at this point.
Sorry for the mis information.
Also this new HD drive has 4 sets of pins. The other HD drives have 5 sets.
according to the cable setting for this new drive it should be in secondary slave position so I repositioned the jumper on the second set of pins from the power cord (3,4).

10-30-2004, 09:51 AM	#3
marvontherim Member (6 bit) Join Date: Oct 2004 Location: Arizona Posts: 60	glc, There is a jumper, it is set on the third set of pins from the power cord. Sorry the older I get the worst my eye's are. This drive took the place of a disk drive in the secondary slave position. The cable is a 40 pin not the 80 if that makes a difference at this point. Sorry for the mis information. Also this new HD drive has 4 sets of pins. The other HD drives have 5 sets. according to the cable setting for this new drive it should be in secondary slave position so I repositioned the jumper on the second set of pins from the power cord (3,4). Last edited by marvontherim; 10-30-2004 at 10:44 AM.