PCMech Forums - View Single Post

jad8271 · 12-30-2004, 10:53 PM

I have two hard drives on my computer
Whenever I start up, either one or the other will detect but not both

the screen will look like this:

Pri. master - (Hard drive name)
pri. slave - None
Sec. master - CD drvie
Sec. slave - CD drive

or this:

Pri. master - None
pri. slave - (Hard drive name)
Sec. master - CD drvie
Sec. slave - CD drive

This is a new problem, both drives used to work
Is there any way to get both drives detected again?

12-30-2004, 10:53 PM	#1
jad8271 Member (1 bit) Join Date: Dec 2004 Posts: 1	no detection I have two hard drives on my computer Whenever I start up, either one or the other will detect but not both the screen will look like this: Pri. master - (Hard drive name) pri. slave - None Sec. master - CD drvie Sec. slave - CD drive or this: Pri. master - None pri. slave - (Hard drive name) Sec. master - CD drvie Sec. slave - CD drive This is a new problem, both drives used to work Is there any way to get both drives detected again?