first build need help on case wires

[cloud7]

this is my first build ive got every thin installed and have wired the case wirse up to the motherboard ive plugged in the system power, speaker, power/soft off button wire , reset button and the hdd led wire but i have another 2 of these wires and can not find were to put them on the motherboard. the motherboard is ASUS A8N5Xand its a antec case. the computer powers up and i can enter bios so it works i just dont know what to do with these 2 other wires. can some one help please :)

[Cricket]

Do the two wires have any markings on the connectors?

:) Cricket

[newbuilder14]

Read the motherboard manual and it will tell you where they go..

[Panama Red]

I bet you're referring to the additional hdd led connectors. Orange and white wires? Antec cases come with 3 of those. I always remove the front of the case, pull two of those wires back thru the case and tie wrap them in a tight bundle for storage between the case and the case front panel. Then snap the front panel back in place.

[cloud7]

thanks, :) yes they are orange and white with hdd led on all 3 does it matter which of the 3 hdd leads i use or can i use any?

[Panama Red]

You can use any of the 3. Just determine which led you want to refer to on the front of the case and trace the wires back so you can plug in the right one.

[cloud7]

ok i will thanks for your help :)