New build problems ... no floppy drive?

[doagie]

First attempt at building a pc.

When I flip the switch, the BIOS starts to boot, but then the MoBo starts beeping incessantly, and I get the following error message:

BIOS ROM checksum error

Detecting IDE ATAPI device ...

Detecting floppy drive A media ...
Drive A error. System halt

I don't have a floppy drive, both my HDD and DVD drive are SATA II (and I have them connected to SATA1 & SATA2, respectively).

I'm guessing I somehow failed to tell the mobo that I don't have any IDE drives, but I haven't been able to figure out how to do that from looking at the manual. Any ideas?

Thanks in advance.

Here's my configuration:
Case: CoolerMaster RC-541-SKR1 (el cheapo 380W PSU included)
MoBo: ASUS M2NPV-VM
CPU: AMD|A64 X2 4800+
RAM: Corsair 240P TWIN2X2048-6400C4
DVD: DVD BURN LITE-ON|LH-20A1L-06
HDD: HD 250G|WD 7K 16M SATA2 WD2500YS

[Cricket]

Go into the BIOS and disable the floppy drive.

:) Cricket

[doagie]

I can't seem to get into the BIOS settings. I've tried pressing Del, Ctl+Alt+Esc, Alt+F2 while booting, but nothing will let me in.

I found this listing of Award beep codes (http://www.computerhope.com/beep.htm#05) ... I guess I'll try re-seating the RAM (and only use one stick) next?

Am I just doing something wrong to get to the BIOS settings?

[Cricket]

Disconnect all drives and then try again. Power up the computer and start hitting the Del key repeatedly until you get into CMOS Setup.

:) Cricket

[doagie]

I disconnect the two SATA cords and retried, but no luck.

I unplugged everything except power, then retried with only one mem stick, and I got into BIOS!

Thanks for your help! I've got my fingers crossed from here ...