byte try this one

[danzigrules]

ftp://setidata.ssl.berkeley.edu/pub/setiathome_win_3_0.exe


the only way I could get it to work was by not saving to disk. Maybe you can get it to work. I'm running it now and will post back as to progress!!

BTW can you send me the info on how to put the seti in my sig?


thx

[danzigrules]

well setispy is saying that i will be done in 5.67 hours at
169.56 megaflops/sec 4.76 cpu cycles/flop 16.85%/hour nice increase from 9.89 hours!!!!

this is on the c2 600

gonna put it on the c466 after w/u is done

[Byte 2.0]

Can you check that link, I can't get it to down or anything.


Also a note on upgrading the seti client, If you are in the middle of a work group it will be re-started, so it is best to upgrade right after you have turned in your previous results...

[danzigrules]

Well when Click the link it goes right to the download box no web page. But I had to open from current location to get the 3.0 client

[Byte 2.0]

ok, it is working from home. It didn't work from work... go figure....

However I was able to follow a link from the seti spy page and I found the mother load....Every Seti verison I think. all of them. I download 3.0 and I can't tell any difference from 2.76. I bet 2.76 was the justa test that worked, then they changed the verison number and decided they were done, just MHO.

[danzigrules]

Can ya be kind and post the link or email or icq it to me?

thx still trying to find one that works well on my 466 cely. like @ 14 hours on it 600 c2 went back up to 11 hours, think I am going back to 2.7 for now till i get abit bx6 board to overclock a little bit..