P4P800 Delux Mem Timeings Bailey? Spyda?

[Frey Grimrod]

Well my P4P800 Delux is up and running flashed to 1009 bios.

Currently running memtest on my matched pair kingston 256mb hyperx 3200's and have yet to encounter a problem at pass 19 but planning on putting it to the real test of Prim95 for 12 hours.

My current settings are 2-3-2-6 with a burst length of 8 and voltage of 2.65 set to run at 200mgh.

I was just curious as to what other timeings people have found to work and if there were any suggestions on manual settings of the dram refresh rate?

[bailey]

2-2-2-5 seam to be the starting point for most expermenting, then go from thereI would jus leave it set to pat and forget it

[lil Jimmie]

I've read that there really isn't too much to be gained by playing with the timmings.

[bailey]

the board is set up just fine with what it can do by its self
with pat and turbo, with thoes two turned on , and it don't boot , then your ram will not perform good enough for the board. any other tweaking of the ram timming will not gain you anything better.

[Spyda]

mines at 2-3-3-6 with GAT, yes GAT on Abits, set to Street Racer, all modes enabled and burst length at auto. with 2.6v.

I can boot but it wont load windows at F1, but ive only ever seen people enable F1 successfully with mushkin or corsair.

dont get the very latest version of prime95, no one i have spoken to can make it run for more than a few minutes, the record ive seen is 16 minutes.

[Frey Grimrod]

Thnx for the opinions.

What version would that be suppose Ill have to go find out...

I ran version 22.12.1 for 4 hours and then my comp locked up but I think this was due to my memory controller overheating I checked my probe records and it had really spiked not to mention the temp was through the roof in this room so I turned on the AC and put a lil fan on my memory controller heat sink and it ran through for 20 hours. Do have turbo and MAM enabled Im thinking about trying to up it to 2-2-2-5 and 50ns...... (just because I can or rather hope I can heh).

Oh and I ran Aida32 got back: write 1639mb/s read 4993mb/s for my memory bench marks....... wouldnt mind seeing those upped a bit....

[Spyda]

download sisoft sandra, you can get the latest off guru3d.com its called sisoft sandra max3

if you can get more than 5000MB/sec in the memory bandwidth benchmark your'e doing fine, im getting about 5200MB/sec at the moment