|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
12-15-2005, 04:37 PM
|
#1 |
|
Member (2 bit)
Join Date: Dec 2005
Posts: 2
|
No video signal out from onboard vga
I'm a newbie to the building world, and I can't even get a signal to my monitor. Here are my specs:
Biostar IDeq 200s Mobo: P4SBA Sis 615 Intel Pentium Celeron D 2.5 GHz Wintec 256MB DDR (2700) Maxtor 200GB HD NEC DVD RW+ I can get the computer to power on, and I see and hear fans moving. When I hit the reset button the LED's on the keyboard flash. I know the monitor works because I can get it with my laptop. So does anyone have any idea as to why this might be happening? Is there a jumper setting that I have to use to activate the onboard video instead of using the AGP slot? Any suggestions would be greatly appreciated. |
|
|
|
12-15-2005, 05:06 PM
|
#2 |
|
Staff
Premium Member
Join Date: Sep 2004
Location: Cardiff, Wales. UK
Posts: 6,105
|
I take it this is a new build never run before?
Are you getting any beeps out of the machine when it starts up?
__________________
Niwa no niwa ni wa, niwa no niwatori wa niwaka ni wani o tabeta. |
|
|
|
12-15-2005, 05:15 PM
|
#3 |
|
Member (2 bit)
Join Date: Dec 2005
Posts: 2
|
This is a new build. All new components.
No beeps or anything, just the fans. |
|
|
|
|
12-15-2005, 05:29 PM
|
#4 |
|
Staff
Premium Member
Join Date: Sep 2004
Location: Cardiff, Wales. UK
Posts: 6,105
|
If you are not getting any beeps that means the machine is not POSTing (Power On Self Test), the most likely cause is a faulty component, but it could also be a short between the motherboard and case, read this thread here about building your machine outside of the case and hopefully you should be able to track down what is causing your problem.
|
|
|
|
|
12-17-2005, 09:19 PM
|
#5 |
|
Member (4 bit)
Join Date: Sep 2005
Location: Levittown,PA
Posts: 15
|
I'm Getting 3 Beeps
This is on a system I know was working before with same monitor.
Had it stored in closet for a while then when I hooked it back up I get a "No signal " message on either of two known working monitors... Suggestions Please? Thanks, Bill 
|
|
|
|
|
12-17-2005, 09:23 PM
|
#6 | |
|
Shiro Usagi
Premium Member
Join Date: Sep 1999
Location: Kaneohe, Hawaii
Posts: 34,002
|
Quote:
 Cricket
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
