|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
03-13-2006, 12:06 AM
|
#1 |
|
Member (1 bit)
Join Date: Mar 2006
Posts: 1
|
New Build - primary IDE master not recognized
It's my first build. I boot it up and it says "Reboot and Select proper Boot device, or Insert Boot Media in selected Boot device and press a key." I try to open up the cd-rom, which is connected correctly and set to master, but it doesnt open. I go to the BIOS and the Primary IDE Master isn't detected. I select CDROM as the Type, reboot, and it still doesnt work. Someone help out a rookie!
|
|
|
|
03-13-2006, 12:42 AM
|
#2 |
|
Member (13 bit)
Join Date: Sep 1999
Posts: 4,956
|
Make sure the ribbon is connected correctly pin 1 on cable to pin one on cdrom,are you using a 40 wire or 80 wire connector?
Is the power plug fully seated on cdrom? Is cdrom sole device on ide 2? |
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
