|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
03-13-2006, 05:33 PM
|
#1 |
|
Member (5 bit)
Join Date: Feb 2006
Location: Georgia/Kentucky
Posts: 24
  |
No Display
I started building a new computer, everything was going fine, all new parts, etc. etc., and after toggling with the FSB in the BIOS there's no display, any clue on how to fix this?
|
|
|
|
03-13-2006, 05:39 PM
|
#2 |
|
Moderator
Staff
Premium Member
Join Date: Aug 2003
Location: Richmond, VA
Posts: 7,835
|
Reset the CMOS by either using the jumpers (see motherboard manual) or pulling the battery for a few minutes. Boot up, and you should be able to access the BIOS again.
kram
__________________
"For today, goodbye. For tomorrow, good luck. And forever, Go Blue!"
University of Michigan President Mary Sue Coleman |
|
|
|
|
03-13-2006, 06:10 PM
|
#3 |
|
Member (5 bit)
Join Date: Feb 2006
Location: Georgia/Kentucky
Posts: 24
|
Worked! Now I get a "Floppy disk(s) failed (40)" error.
|
|
|
|
|
03-13-2006, 07:25 PM
|
#4 |
|
Served with Pride
Staff
Premium Member
Join Date: Apr 2003
Location: near the left coast of Michigan
Posts: 14,565
|
Do you have a floppy attached? If not, disable it in the bios. If you do, recheck it for proper cable orientation.
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
