|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
07-28-2006, 04:19 PM
|
#1 |
|
Member (6 bit)
Join Date: Apr 2006
Posts: 33
|
First build questions
Is there any differences when installing dual rails then single rails?
Also for an SATA drive I know that there are four connectors which ones are the ones that I want to install? I have the SATA power wire and the SATA motherboard wire is that all that it needs or is there another one I need to plug in? Antec Sonata II Pentium D 940 ASUS P5LD2 eVGA GeForce 7600GS Lite-on DVD RW Western Digital Caviar 250GB 16mg Cache pqi TURBO 1GB 240-Pin DDR2 |
|
|
|
07-28-2006, 04:22 PM
|
#2 |
|
Member (7 bit)
Join Date: Jul 2006
Posts: 87
|
I think that's it. I'm not sure...
|
|
|
|
|
07-28-2006, 04:33 PM
|
#3 |
|
Member (12 bit)
Join Date: Sep 2005
Posts: 2,509
|
No difference installing a dual rail PSU than a single rail.
The differences are internal to the PSU. Sata Hd put it in the lowest numbered (o or 1) connector on the primary SATA controller. There are 2 power connectors on a lot of SATA drives, a SATA power connector and a legacy Molex connector. Use one or the other, preferably the SATA, but not both.
Last edited by jayb1234; 07-29-2006 at 03:17 AM. |
|
|
|
|
07-28-2006, 05:13 PM
|
#4 |
|
Member (6 bit)
Join Date: Apr 2006
Posts: 33
|
Thank you
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
