|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
01-24-2007, 04:36 PM
|
#1 |
|
Member (7 bit)
Join Date: Jun 2005
Posts: 80
|
Help needed for assembly
I recieved everything in the mail today for my build, I'm having a little trouble hookin up the cables from the fans and the LED dislay on the front of the computer. I have a Thermaltake Xaser V1000+ case, the manual included is god awful, I recieved 2 4-pin cables with 3 4-pin connectors on each cable, the fan cables have a male and a female 4-pin connector, any idea on how to hook this together would be appreciated.
|
|
|
|
01-24-2007, 04:59 PM
|
#2 |
|
Wrench Bender
Join Date: Dec 2002
Location: Plymouth,MN
Posts: 5,961
|
The case fans can be daisy chained together and depending if the Xaser came with a fan controller, the fans connected to that. If no controler, then connect to a 4 pin molex from the PSU. The manual that came with my Xaser III was pretty good. Had to read the whole thing due to some of things at the end needed to be done at the start.
__________________
"When sliding down the banister of life; look out for splinters pointing up."
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SATA drive install - Drivers needed or NOT? | ukdave | Computer Hardware | 22 | 01-16-2007 08:41 AM |
| is Qos Packet Scheduler needed | toomyg | Networking & Online Security | 6 | 03-04-2006 10:48 AM |
| RAM needed to run Dual Channel | foolishone | Computer Hardware | 2 | 01-05-2005 11:20 AM |
| new power supply needed? | green3500 | Computer Hardware | 3 | 12-01-2002 08:00 PM |
| windows files needed after service pack | brentconn | Windows Legacy Support (XP and earlier) | 0 | 11-04-2002 04:29 PM |
Linear Mode
