|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
11-09-2007, 03:21 PM
|
#1 |
|
Member (7 bit)
Join Date: Oct 2007
Location: Alabama
Posts: 102
|
Hangs up verifying DMI pool data
New build.
Processor E6750 MB gigabyte GA-P35-DS4 rev 2 http://www.gigabyte-usa.com/Support/...ProductID=2585 Hard Drive Seagate HD 500G|ST 7K 16M SATA2 ST3500630NS OEM Fires up fine Set boot to DVD drive Windows started to load, did the F6, and the S thing, loading all kinds of stuff . Hit enter to load windows got to the EULA if you accept press F8 pressed F8 nothing happened, Shut down restarted Now Hangs up verifying DMI pool data. If I shut down, Pull the HD sata cable it boots , starts the windows thing . I sneakily put the sata cable back in the HD windows starts to load but hangs again at accepting the EULA . I have cleared the CMOS set the BIOS to fail safe tried various s Sata cables and various positions on the MB Memory looks good on start. Could use some pointers or a slap side of the head
__________________
hudson80 Build 10 November 07 so far not even a hiccup. No over clocking Gigabyte Poseidon Case, gigabyte GA-P35-DS4 Rev 2 , BIOS F11 PSU corsair 620HX, CPU Intel C2D E6750 2.66 gig, Memory Crucial, 8 gig ,(4 X 2 G sticks) DDR2 800 (PC2 6400) 1.8 volt GPU PNY 8500GT 512MB. 2 Seagate internal SATA HD 1 Seagate eSATA HD all running AHCI. Lite On SATA DVD DL burner, Lite on SATA DVD burner. Floppy drive . Dual Boot Vista HP 64/, Windows 7 RC1,monitor Samsung T260HD |
|
|
|
11-09-2007, 05:15 PM
|
#2 |
|
Member (7 bit)
Join Date: Oct 2007
Location: Alabama
Posts: 102
|
Changed boot order got past the DMI thing still won't get past eULA to vconinue XP install I pull 2 gigs of ram no help
|
|
|
|
|
11-09-2007, 05:24 PM
|
#3 |
|
Wrench Bender
Join Date: Dec 2002
Location: Plymouth,MN
Posts: 5,961
|
With the mobo you have, shouldn't need to do the F6 thing to install "mass storage devices" which was how SATA drivers used to be loaded. Your board will have SATA native. May need to check SATA settings in the BIOS.
__________________
"When sliding down the banister of life; look out for splinters pointing up."
|
|
|
|
|
11-09-2007, 07:06 PM
|
#4 |
|
Member (7 bit)
Join Date: Oct 2007
Location: Alabama
Posts: 102
|
It R fixed. Needed a keyboard so bought a cheap MS type. After fifty million times hanging up at accepting the EULA, noted a key that said F Lock. Hit that sucker and we are gioing to town.
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DMI pool | Airmack | Windows Legacy Support (XP and earlier) | 9 | 09-08-2002 11:06 AM |
| DMI Pool Data | andrewp | Computer Hardware | 3 | 05-03-2001 01:53 PM |
| Verifying DMI pool data | andrews1960 | Windows Legacy Support (XP and earlier) | 3 | 03-12-2001 03:20 AM |
| Stuck @ "Verifying DMI Pool Data", any clues? | SpiderLee | Computer Hardware | 9 | 01-20-2001 10:58 AM |
| Verifying DMI pool data | Zdenko | Computer Hardware | 4 | 01-10-2001 04:04 PM |
Linear Mode
