|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
07-31-2011, 12:30 AM
|
#1 |
|
Member (7 bit)
Join Date: Mar 2011
Posts: 82
|
New SSD install..
OK so im installing a new vertex 3 boot drive into my rig.... (X58A-UD5)
i have been doing allot of reading and have found that my mobo's marvell 9128 controller will not fully support 6.0 Gbps (sata3). iv also read that it is a waste of time trying as this controller is a dud.... SO.... i guess i will have to run it on a ICH10R intel SATA II port. Question 1... is this correct? Question 2... how do i change from IDE to AHIC mode on the intel sata II controller? thanks |
|
|
|
08-06-2011, 02:19 AM
|
#2 |
|
Member (7 bit)
Join Date: Mar 2011
Posts: 82
|
(silly question really)
im running all my drives on the intel controller in [a] mode now.. seems to be good. ((no 6 megabitspersecond but ohwell, OCZ-V3 sandforce boot is lush! even at sata II !!!!))  
|
|
|
|
|
08-06-2011, 03:31 AM
|
#3 |
|
Tweak Monster
Join Date: Sep 2003
Location: indiana
Posts: 2,960
 |
yeppers I run a 128gb SSD on my P55 and it works well...boots quick and I run AHCI too
__________________
MSI 890GXM-G65 mATX/1075t/G-Skill DDR3-1600 2x4gb /WD 640 aaks 95mb/s /XFX 5830/Zalman9700nt/ Thermaltake TP750w modular ECS P55 Black Edition/i7-860/Geil Black Dragon 2x2gb 12800-ddr3/Asus 5970X2 vid card/2x640 AALS-Raid-0/Corsair TX-850w |
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
