|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
08-11-2004, 10:59 AM
|
#1 |
|
Banned
Join Date: Jul 2004
Location: NYC!!! and proud of it (screw Osama and all of his hobo friends)
Posts: 105
|
how do you remove a dry face plate??
The title is the question This must be a stupid question but I really don't know a little help plz?
|
|
|
|
08-11-2004, 11:09 AM
|
#2 |
|
Member (11 bit)
Join Date: Dec 2001
Location: Shakopee MN
Posts: 1,293
|
If I am hearing this right you have a plastic face plate that has stiffened up over time and you need to remove it to add a drive.....the solution is heat - try a hair dryer on high on the tabs holding it in place. The heat will soften the plastic a little and make it less brittle/rigid. Still- be careful on the removal assuming that you want to save the plate for possible future use, plastic gets brittle over time especially in the presence of heat that cooks out the chemicals that give it flexibilty..
__________________
Never Argue With An Idiot. They'll Drag You Down To Their Level And Then Beat You With Experience. |
|
|
|
|
08-11-2004, 01:44 PM
|
#3 |
|
Banned
Join Date: Apr 2004
Posts: 350
|
take a demolition hammer to that mofo. or use a zippo lighter.
|
|
|
|
|
08-11-2004, 02:48 PM
|
#4 |
|
Member (9 bit)
Join Date: Jun 2004
Location: GA
Posts: 302
|
lol i486. demolition hammer? lmao that's hilarious. i wouldn't do that tho, like sdkfz said, you mite want it for future use, so save it by using a hair dryer.
|
|
|
|
|
08-12-2004, 03:07 AM
|
#5 | |
|
Shiro Usagi
Premium Member
Join Date: Sep 1999
Location: Kaneohe, Hawaii
Posts: 34,002
|
Quote:
 Cricket
|
|
|
|
|
|
08-12-2004, 09:30 PM
|
#6 |
|
Banned
Join Date: Jul 2004
Location: NYC!!! and proud of it (screw Osama and all of his hobo friends)
Posts: 105
|
the front panel but with a fresh case or is there instructions with the case manual???
|
|
|
|
|
08-12-2004, 09:34 PM
|
#7 |
|
Shiro Usagi
Premium Member
Join Date: Sep 1999
Location: Kaneohe, Hawaii
Posts: 34,002
|
Which case are you using?
On most current cases, the front panel is just held on with lock tabs that slip into slots in the metal chassis. To remove the front panel, you have to "unlock" or lift these lock tabs so that they can be pulled free from the chassis. On older cases, the front panel was often held on with screws. Cricket
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
