|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
12-30-2004, 11:53 PM
|
#1 |
|
Member (1 bit)
Join Date: Dec 2004
Posts: 1
|
no detection
 I have two hard drives on my computer Whenever I start up, either one or the other will detect but not both the screen will look like this: Pri. master - (Hard drive name) pri. slave - None Sec. master - CD drvie Sec. slave - CD drive or this: Pri. master - None pri. slave - (Hard drive name) Sec. master - CD drvie Sec. slave - CD drive This is a new problem, both drives used to work Is there any way to get both drives detected again? |
|
|
|
12-31-2004, 01:27 AM
|
#2 |
|
Forum Administrator
Staff
Premium Member
Join Date: May 2000
Location: Joplin MO
Posts: 36,460
|
Reseat the cables and verify correct jumpering. Try a new ribbon cable.
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
