Rubber Molding for Case Mod

[RJS2]

Not sure if this is the right forum. I am planning on adding fans to my Lian-Li case and i like the molding has sticky stuff on inside pictures below id like to put around the hole after i cut it out with the dremel. I found prices at frozencpu and xoxide for 1.99 a foot plus shipping but was wondering if anyone knew where i could find this exact or close to the same stuff at locally because it costs too much to have shipped by itself.

Ive looked at Lowes, Home Depot and Autozone without any luck of that same stuff.

[shadowbreaker513]

If you can find a best buy that still carries Modware stuff, buy it. I got a laser cut fan grill, an 8.5"x11" acrylic window with 2 sizes of that molding, an 18" round floppy cable, and a red cold cathode with inverter for $8 from there. The window kit sounds perfect for you. Acrylic and molding.

[RJS2]

Yea i done got the fans and grills from newegg but they didnt carry that stuff or i would have added it since i already payed $5.00 shipping which wasnt bad i got 6 fans and 8 grills to go with them im replacing the stock fans in the case but i wanna put that molding around em and dont wanna pay the outragous price to have it shipped. Ill take a look at Circuit City i have one of them close by maybe they will have it or drive up to Best Buy.

[FLG]

dee, if you can find it good luck. I did the same thing went everywhere...and tried every other molding, and wound up buying the one they sell at frozen. Im pretty shure i have a few feet left over somewhere....if i find it, its yours.