Go Back   PCMech Forums > Help & Discussion > Computer Hardware

Need Some Help? Type Your Keywords Here:

Reply
 
LinkBack Thread Tools Search this Thread Rate Thread Display Modes
Old 03-24-2005, 01:51 PM   #1
Member (7 bit)
 
kazz0817's Avatar
 
Join Date: Aug 2004
Posts: 122
cpu fan question

i have a upper side fan on my case which i have blowing directly towards my cpu also a cpu fan blowing down onto the cpu

However i just bought a zalman cooler which is huge (the flower type ones) and not sure if i ca change the airflow of the fan on it (unsure how to remove fan) should i turn my upper left case fan facing out of the case and have cpu fan blowing the same way so that the cpu fan is blowing directly into my upper left exhaust fan? or should i have cpu fan blowing to cpu and upper left case fan exhausting (opposite to cpu)
kazz0817 is offline   Reply With Quote
Old 03-24-2005, 02:01 PM   #2
Member (9 bit)
 
RJS2's Avatar
 
Join Date: Jul 2004
Location: Indiana
Posts: 257
You should have your cpu fan blowing down on the heatsink/cpu and if your case fan your talking about is on top then i would have that blowing outwards since hot air rises would make your case cooler on the inside , since heat gets stuck at the top and has no where to go.
RJS2 is offline   Reply With Quote
Old 03-24-2005, 04:53 PM   #3
Member (7 bit)
 
kazz0817's Avatar
 
Join Date: Aug 2004
Posts: 122
no the fan i mean is on the side door upper (facing cpu fan)
kazz0817 is offline   Reply With Quote
Old 03-24-2005, 05:15 PM   #4
Served with Pride
Staff
Premium Member
 
Panama Red's Avatar
 
Join Date: Apr 2003
Location: near the left coast of Michigan
Posts: 14,538
Send a message via AIM to Panama Red
Air flow is an interesting subject and results vary from one case to another. Any fan mounted in the rear OR above the mid line of the case should exhaust air from the case (blow out). Any fan mounted in the front or below the mid line should intake air to the case (blow in). However, you never want more intake volume than exhaust since that will cause a pressure build up inside the case and prevent the proper evacuation of the heated air inside. My suggestion would be a trial and error experiment. Start with the side fan disconnected. Make sure you have plenty of rear exhaust and unobstructed intake. You can enhance the intake with an additonal fan but it may not be necessary. Check your case temps and cpu temps and keep track of the effects the changes make. Once you have a stable case temp, try running the side fan as an additional exhaust and see what effect that has on the temps. Then reverse that side fan and make it blow in. See if the temps go up or down. I don't believe anyone is going to give you the definitive answer on which way is best. You'll be better off experimenting.
__________________
Computers have enabled people to make more mistakes faster than almost any invention in history,
with the possible exception of tequila and hand guns.
Panama Red is offline   Reply With Quote
Old 03-24-2005, 08:30 PM   #5
Shiro Usagi
Premium Member
 
Cricket's Avatar
 
Join Date: Sep 1999
Location: Kaneohe, Hawaii
Posts: 34,002
Quote:
Originally Posted by kazz0817
However i just bought a zalman cooler which is huge (the flower type ones) and not sure if i ca change the airflow of the fan on it (unsure how to remove fan) should i turn my upper left case fan facing out of the case and have cpu fan blowing the same way so that the cpu fan is blowing directly into my upper left exhaust fan? or should i have cpu fan blowing to cpu and upper left case fan exhausting (opposite to cpu)
The Zalman heatsink was engineered so that the fan blows towards the CPU...you don't want to change the direction the fan is blowing or you could end up with higher CPU temps.

As far as the side fan goes, do as Panama Red suggested to find out which orientation works best for your particular computer.

Cricket
Cricket is offline   Reply With Quote
Old 03-25-2005, 03:38 AM   #6
Member (7 bit)
 
kazz0817's Avatar
 
Join Date: Aug 2004
Posts: 122
huge help thanks guys
kazz0817 is offline   Reply With Quote
Old 03-25-2005, 08:06 AM   #7
Member (7 bit)
 
kazz0817's Avatar
 
Join Date: Aug 2004
Posts: 122
quick question, my front intake is an 80mm and it doesnt feel like it is doing much, it seems to blow fine but it doesnt seem to suck much in, is this normal? maybe its sucking more in than i can tell but i have to wet my finger and place it near the fan to feel anything being pulled in, yet on the other side it feels a little stronger the airflow, is it possible to get more powerfull 80mm fans? im using the stock 80mm thermaltake that came with my xaser V case, should i keep it or look for something more powerfull (if possible) also where will i find powerfull 80mm fans online (UK) or a good fan store, recommendations would be great
kazz0817 is offline   Reply With Quote
Old 03-25-2005, 08:27 AM   #8
Member (12 bit)
 
Yuanji's Avatar
 
Join Date: Aug 2004
Location: NYC, NY
Posts: 2,558
i think it's always easier to notice exhaust then intake no matter what simply because the force of the air isnt going into your hand. more powerful fans are availible but usually you want to keep the exhaust power either equal or slightly more then your intake. if you don't mind noise, vantec tornados are amazing power. you could also look towards the panaflo line for quieter performance although i'm not sure how well their 80mm series performs.
__________________
My 1st Build: Antec SuperLANboy Case| Antec 480W Neopower| 16X Sony DVD-ROM | Nec 1.44 FDD | WD 74GB Raptor 10,000 RPM SATA HDD | Aspire Keyboard w/optical Mouse |Geil Value 1Gig| ASUS P4P800-E Delux Socket 478 | P4 3.2E 800FSB HT | eVGA GeForce 6800GT 256MB
Yuanji is offline   Reply With Quote
Old 03-25-2005, 10:50 AM   #9
glc
Forum Administrator
Staff
Premium Member
 
glc's Avatar
 
Join Date: May 2000
Location: Joplin MO
Posts: 36,460
Disconnect the front fan and see what that does. I've stopped using front fans - the exhaust fans will draw air through the case.
glc is offline   Reply With Quote
Old 03-25-2005, 02:27 PM   #10
Served with Pride
Staff
Premium Member
 
Panama Red's Avatar
 
Join Date: Apr 2003
Location: near the left coast of Michigan
Posts: 14,538
Send a message via AIM to Panama Red
Quote:
Originally Posted by glc
Disconnect the front fan and see what that does. I've stopped using front fans - the exhaust fans will draw air through the case.
I agree with glc. Disconnecting and removing the front fan often "opens up" the intake area and allows a better flow of air from the front to the back with just the rear fan "pulling" the air thru. Hence my mention of "unobstructed" air intake in my ealier post.
Panama Red is offline   Reply With Quote
Reply

Bookmarks

Still Need Help? Type Your Keywords Here:


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -5. The time now is 11:25 PM.
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2012, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0