I need a help.

[monrroy24]

I have a problem to install a cd-rw as a second drive.
I am using a old computer with a intel celeron processor and a motherbord dfi,
so I follow the instruccion to install it but when I test it, when is staring the light come on but after 5 to 10 minutes after is on the cd-rw go off, and the first cd is still on, end there are installed on the same ide cable. also the computer recconize the 2 drives end show
that are working properly, I installed the drivers end sofewere twice to be sure to aviod problem wich drivers.
any help, thank you in advance.

[Cricket]

Are both drives jumpered properly for the type of IDE cable they're connected to?

If 40 wire IDE cable, set the jumpers to master or slave.

If 80 wire IDE cable, set the jumpers to CS (cable select) and make sure you have the cable connected properly (blue to motherboard, black to burner, grey to reader.

Try the new burner in another computer. If it doesn't work there, it's broken.

Cricket

[monrroy24]

ok. i try it in another computer and it work fine. and yes I set the jumper,
but on the cumpeter thet a used don,t.