CD R/W not recognized

[Hot Rod]

I am working on a PC that is having a problem with the CD R/W. I installed the CD R/W as master on the secondary IDE and the normal CD Rom as the slave on the secondary IDE per the instructions that were sent with the CD R/W. The CD R/W was picked up as a Lite-on LTR 12102C. I popped in a CD and was able to read and install a program from it fine. I installed NTI CD Maker 2000 which came with the CD R/W. When I try to open NTI CD Maker 2000, it says that it does not recognize that a supported CDR or CD R/W is attached. I checked again and I could still insert a CD into it and it was able to read it fine.

To experiment, I attached the normal CD ROM as slave on the primary IDE with the hard drive and left the CD R/W as master on the secondary to see if it needed to be by itself. Same error when opening NTI CD Maker.

Any ideas?

[HAL9000]

Make sure that you have at least version 4.1.46 of the NTI software. If not, get the update.

[Hot Rod]

Thanks HAL9000.....that was it.