|
|||||||
![]() |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
|
|
#1 |
|
Member (4 bit)
Join Date: Oct 2006
Posts: 12
|
When I replace a case fan, does it have to be the same amps rating?
I have a computer that is several years old. The case fan went T. U. so I want to replace it but I can't find a fan that is rated at 0.30A. Do I need the same amps or can I go lower? Does the new fan have to have 3 wires also or can it have two? What is the net effect?
THX |
|
|
|
|
|
#2 |
|
Served with Pride
Staff
Premium Member
|
A fan with lower amperage should be no problem at all. One with higher amp draw may be a concern due to the mobo circuit's ability to support higher current without burning something up. Even that is highly unlikely tho. A 3 wire connection is for fan speed monitoring. One wire is the 12v +, one the 12v -, and the third is the speed detection. Running without speed detection is not a problem. Check in your bios for the fans that are monitored. If the case fan is listed you may need to Disable the monitoring to prevent a naggin pop up or beep code.
__________________
Computers have enabled people to make more mistakes faster than almost any invention in history, with the possible exception of tequila and hand guns. |
|
|
|
|
|
#3 |
|
Member (4 bit)
Join Date: Oct 2006
Posts: 12
|
Thx
|
|
|
|
![]() |
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fan control & Temp sensing | balroggie | Build Your Own PC | 1 | 03-03-2006 08:02 PM |
| case fan dying? | peekaboo | Computer Hardware | 8 | 02-16-2006 10:20 PM |
| Direction of the fan on my ATX case??? | shoesup | Computer Hardware | 3 | 06-03-2004 10:21 PM |
| Turning a "cheap" case into a low temperature work horse | KMARTshopper | Computer Hardware | 0 | 12-16-2003 01:24 AM |
| Something wrong wit case temps. | phatboi | Computer Hardware | 23 | 05-21-2002 08:10 AM |