|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
03-30-2003, 04:57 PM
|
#1 |
|
Wrench Bender
Join Date: Dec 2002
Location: Plymouth,MN
Posts: 5,949
|
flatbed scanner install onto a NT machine
I'm trying to use a leftover Win NT machine to install a parallel port flatbed scanner for saving misc. paper work in my shop at work. The problem comes when installing the scanner software; it installs ok but when complete it says can't find the scanner. After looking at the help section of the software it says to log in as administrator. Since I don't have the admin password, am I going to have to reload NT or is there another solution?
scanner: Microtek Slimscan C3 computer: Gateway 400 Thanks |
|
|
|
03-30-2003, 10:12 PM
|
#2 |
|
Member (10 bit)
Join Date: Feb 2002
Location: Rhode Island
Posts: 584
|
Try playing around with software like (deleted by moderator)
Moderator note: We can't allow discussions here related to bypassing security. Last edited by glc; 03-31-2003 at 03:21 AM. |
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
