Problem with LX-300+

[easg]

I have problems printing with two LX-300+ printer in a network
first I sent a exel spreadsheed to a local printer and it prints wrong caracters and un alingment lines, so I set up a networked printer, and it prints the same garbage, some caracters are ok others dont, lines un alingment, but that´s not all, we I send a print job from a ms-dos based program both of them print OK.

I checked the configuration of both printers and are OK, I even formated a Hard Disk in the case of a virus and nothing.

[glc]

Try different printer drivers - Windows can have problems with dot matrix printers when you are printing graphics. That's a generic 9 pin, almost any Epson 9 pin driver should work, try them till you find the one that works right.

[easg]

I tryed with the lx-800 400 300 and the cd driver and nothing

[glc]

Try one of the FX/LX 80 or 86 drivers, that's the original 9 pin Epson driver.

Find a manual for the printer and try setting it to different emulations. Try a different printer cable.