|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
12-10-2004, 01:17 PM
|
#1 |
|
Member (9 bit)
Join Date: Jun 2004
Location: Dixon, Illinois
Posts: 318
|
Unable to send results?
I am getting an error message on my folding about not being able to contact the work server (results). Apparently I can get new work units, but I can't seem to send the results back. Nothing has changed on my computer, firewall is allowing it, and I haven't added anything that would prevent it from working. Our cable went out a few days ago for the better part of a day, but I have been able to send and receive since then. Today is the first I noticed the problem.
If anyone has any suggestions, I'd appreciate them. Scomac |
|
|
|
12-10-2004, 01:41 PM
|
#2 |
|
Member (12 bit)
Join Date: Dec 2001
Location: St. Louis, Missouri
Posts: 3,294
  |
The Stanford servers go down from time to time. One of my clients right now is unable to retrieve any work. There used to be a page that listed the servers and their current status, but I can't find that link back. I'll let you know if I can dig it up. Give it a day or two, and it should start working again.
__________________
Kov Are You Foldin'? Join PCMech's Folding@Home Team and Help Save Lives! Click Here!
|
|
|
|
|
12-10-2004, 01:43 PM
|
#3 |
|
Member (9 bit)
Join Date: Jun 2004
Location: Dixon, Illinois
Posts: 318
|
Thanks for the quick reply Kov-Ice. If you find that link about their server status, I'd appreciate it if you did post it.
Thanks again for your quick reply! Scomac |
|
|
|
|
12-10-2004, 02:45 PM
|
#4 |
|
Member (12 bit)
Join Date: Dec 2001
Location: St. Louis, Missouri
Posts: 3,294
|
Found it. Folding@Home server status updated every 10 minutes.
|
|
|
|
|
12-10-2004, 02:53 PM
|
#5 |
|
Member (9 bit)
Join Date: Jun 2004
Location: Dixon, Illinois
Posts: 318
|
Thanks for the link about the servers. I just checked and it was able to connect now and the work unit has been submitted.
Scomac |
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
