|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
01-21-2002, 02:12 PM
|
#1 |
|
Member (8 bit)
Join Date: Jan 2002
Posts: 139
|
zone alarm
I've been using zone alarm with a cable modem for a while now without any problems, but lately when I leave the computer idle and it goes into it's lock mode, I unlock and try to connect it doesn't work. I have to manually go into the ip config and renew the IP. Before, I could get home from work, unlock and open browser or email. Also, now it seems if I wait about five minutes after unlock, the modem will find an IP. Not a big deal but it was a little quicker to just unlock and connect. Any ideas on this one?
Thanks |
|
|
|
01-21-2002, 02:54 PM
|
#2 |
|
Member (6 bit)
Join Date: Dec 2001
Posts: 50
|
dtro,
Go to the Security Settings in ZA. Click on the Advanced tab. Under "Other Computers" you should have a DHCP server listed. This is shown when you run "winipcfg" under "more info". At least that's what my cable provider told me and it seems to work. |
|
|
|
|
01-21-2002, 06:15 PM
|
#3 |
|
Member (8 bit)
Join Date: Jan 2002
Posts: 139
|
Thanks!
I will try that thanks very much!
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
