|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
08-22-2004, 10:44 PM
|
#1 |
|
Member (8 bit)
Join Date: Sep 2002
Posts: 138
|
Network setup help
I am trying to get a linksys wmp11 wireless B-card to work with linksys wireless wrt54G router. The problem I am having is that I cannot get it to connect to router. It is picking up a signal,but just is not connecting. Both computers are using windows xp. Does anyone have any ideas what I can do to make this work?
 It is using static ip address on the router.
|
|
|
|
08-22-2004, 10:46 PM
|
#2 |
|
usual suspect
Join Date: Jun 2002
Location: not here
Posts: 2,051
|
do you have wep enabled on the router? if so, you will need to put the wep key on the comp with the card. also, you will need to give the comp an ip if you are using static ip (that is, you have dhcp disabled)
craig
__________________
the universe is against this current wave of success i'm having. -johnny drama, entourage |
|
|
|
|
08-22-2004, 10:53 PM
|
#3 |
|
Member (8 bit)
Join Date: Sep 2002
Posts: 138
|
I am trying to set this up for someone else. It is not using a wep key. I am not sure if the dhcp is disable. I am not where the computer is right now I will have to get back with you on that. I am just trying right now to figure out what I can do to fix it when I get back to it.
|
|
|
|
|
08-22-2004, 11:00 PM
|
#4 |
|
usual suspect
Join Date: Jun 2002
Location: not here
Posts: 2,051
|
let me just make sure we are on the same page before you disable dhcp. did you assign an ip to the computer that is working? did you also assign an ip to the computer that is not working. if the router is in fact using dhcp, make sure the comp that isn't working is set to receive an ip automatically
craig |
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
