|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
06-07-2005, 04:12 AM
|
#1 |
|
Gremlin Overlord
Join Date: Apr 2003
Location: Australia
Posts: 2,382
|
Help with MATLAB
Basically, there's a toolbox on MATLAB which I want to use, and I was wondering if anyone had any experience in using it. It's the Communications Toolbox in MATLAB, and I want to use it to simulate/model a signal. I was hoping perhaps someone had used it before, or knew where a good introduction to it could be found
|
|
|
|
06-07-2005, 12:09 PM
|
#2 |
|
Member (7 bit)
Join Date: Aug 2004
Posts: 108
|
Well, in the help of Matlab there is a good amount of information about any toolbox as well as interactive examples. You can check as well webs like www.matlabcentral.com
|
|
|
|
|
06-09-2005, 01:58 AM
|
#3 |
|
Gremlin Overlord
Join Date: Apr 2003
Location: Australia
Posts: 2,382
|
Yeah, I've seen that thanks. I was just hoping someone had perhaps used this particular toolbox at some stage, to pass on some tips. But thanks palloco
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
