|
|||||||
 |
|
|
LinkBack | Thread Tools | Search this Thread | Rate Thread | Display Modes |
07-08-2006, 03:39 PM
|
#1 |
|
Member (7 bit)
Join Date: Jun 2004
Posts: 97
|
Windows XP Repair with RAID 0 Configuration
I need to repair my installation because some spyware removal program killed the screensaver function. My C drive is setup in a RAID 0 configuration. When I boot from the Windows XP CD, I go through the various screens until it says I do not have an installation on any "mass storage" device.
Windows accesses the RAID 0 setup when I boot up so I cannot figure out what to do ... Any advice or suggestions would be greatly appreciated! Thanks in advance ... |
|
|
|
07-08-2006, 03:47 PM
|
#2 |
|
Forum Administrator
Staff
Premium Member
Join Date: May 2000
Location: Joplin MO
Posts: 37,786
|
You need to press F6 and load the RAID drivers just like you did when you first installed Windows.
|
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
