ICS using dial up in 2k can't see host or call on dialup

[videobruce]

I have read the M$ KB articles on ICS and dial up, but can't get the client to call the dial up on the Host (Gateway) computer through a wireless NIC/router setup.

I looked at the settings and both are on the same domain name, both have the IP address set for automatic. ICS is enabled on the host.

The setup is:

Win 2k
Host (Gateway, tower box) wired NIC
Client (Laptop box) wireless NIC

Compaq CP-2W router.
Dial up ISP.

Host can see client, but client CAN'T see host or call up the dialup.
Dialup works from host ok.

What am I missing? Hope this makes sense.

[videobruce]

I have gone here, but the best I can do is see each box and access the dialup only throught the host. The client (Laptop) can't do it.

http://www.practicallynetworked.com...install_dup.htm


I think it is a problem with the Compaq CP-2W router